Acura 22810-PG2-004 Bearing, Clutch Release (Koyo)

You can Select Your Vehicle to check if 22810-PG2-004 fits your vehicle.

Access to the clutch components is normally accomplished by removing the transaxle, leaving the engine in the vehicle. To support the clutch disc during removal, install a clutch alignment tool through the clutch disc hub. Carefully inspect the flywheel and pressure plate for indexing marks and turn each bolt a little at a time to loosen the pressure plate-to-flywheel bolts. Inspect the flywheel for cracks, heat checking, grooves and other obvious defects and the lining on the clutch disc for loose rivets, distortion, cracks, broken springs and other obvious damage. Clean the flywheel and pressure plate machined surfaces with brake cleaner, lacquer thinner or acetone and position the clutch disc and pressure plate against the flywheel with the clutch held in place with an alignment tool. Center the clutch disc by ensuring the alignment tool extends through the splined hub and into the pocket in the crankshaft. Lubricate the inner groove of the release bearing and install the clutch release bearing. Install the transaxle and all components removed previously and tighten all fasteners.

Attach the release bearing to the release fork on Legend models, slide the release bearing onto the transaxle input shaft front bearing retainer while passing the end of the release fork through the opening in the clutch housing on Legend models, position the bearing and fork assembly on the transaxle input shaft and slide the release shaft through the release fork on lntegra models, align the holes and install the bolt, tightening it, and apply a light coat of high temperature grease to the face of the release bearing where it contacts the pressure plate diaphragm fingers.