Acura 68500-SEP-A92ZZ Lid, Trunk (Dot)

You can Select Your Vehicle to check if 68500-SEP-A92ZZ fits your vehicle.

The trunk lid is heavy and somewhat awkward to remove and install, so at least two people should do this procedure. So start by opening the trunk lid and removing the trim panel that is fastened with push fasteners and a screw at the handle, as well as the cushions. For correct routing during reinstallation, unplug the electrical connector for the trunk lid latch and disconnect the release cable, and tie string or wire to the harness and cable. Use an assistant to support the trunk lid while you remove the hinge to trunk lid bolts on both sides of the trunk hinges, marking the alignment around the trunk hinges. Remove the trunk lid, reverse the removal steps, but do not install the trim panel until the alignment has been verified, and reverse the remove steps along with lifing off the trunk lid. Close the lid after installation so that you can check its alignment with other body surfaces. Remove trim panel and rear shelf; loosen hinge bolts and reposition the lid as needed. To adjust the height of the closed trunk lid, set the striker up/down or left/right, making a reference mark around the striker before adjustments. Edge cushions on the lower edge of the trunk lid are also adjustable and can be turned in order to fine tune raise or lower it as needed.