Acura 52610-ST7-R02 Rear Shock Absorber Assembly (Showa)

You can Select Your Vehicle to check if 52610-ST7-R02 fits your vehicle.

Guide the shock absorber assembly into the fenderwell and insert the upper mounting studs through the body holes. Install the nuts to prevent the assembly from falling back through, without fully tightening them yet. Enlist assistance due to the weight of the shock absorber. Insert the lower end of the shock absorber into the damper fork, ensuring alignment between the tab on the shock body and the slot in the fork. Connect the damper fork to the lower control arm, simulate normal ride height by raising the lower control arm with the floor jack, then tighten the self-locking nut and the damper fork pinch bolt. Reconnect the stabilizer bar to the control arm, secure the brake hose to its bracket, and tighten the bolt firmly. Install the wheel, tighten the lug nuts, lower the vehicle, and further tighten the lug nuts. Finally, complete the process by tightening the upper mounting nuts.

Installation is the reverse of removal. Before tightening the shock absorber lower mounting bolt, raise the rear of the trailing arm with the floor jack to simulate normal ride height and be sure to tighten all fasteners.

Mount the shock absorber assembly in a vise, line the vise jaws with wood or rags to prevent damage to the unit and don't tighten the vise excessively. Mark the relationship of the damper mounting base to the spring.